Teléfono : +86 177 0197 3016
Correo electrónico : sales@isoautotest.com
Product Introduction:
This equipment uses helium to test the sealing of both sides of the battery end cover. Helium surrounds one end, and the detector captures leakage signals from the other end, enabling a rapid and accurate judgment of whether there is any leakage.
Certificación :
Calibration Certificate(cost additional)Precio :
NegotiableEl tiempo de entrega :
90 DaysTérminos de pago :
L/C, T/TNombre de la marca :
HCTENúmero de modelo :
HCTE0037Product Features:
The equipment adopts process automation technology, combining process equipment with electrical automatic control technology. The entire workpiece inspection process is automatically controlled by PLC and touch screen, allowing operators to simply install and unload workpieces. Compared to the customer's original equipment, it eliminates the need for operators to judge the results of each process step. Instead, the PLC program automatically judges the results of the previous step and executes the next step based on preset conditions. This not only saves physical labor but also replaces the operator's judgment and execution.
Product Parameters:
Number of Workpieces Tested Each Time |
1 piece |
Inspection Chamber Size |
φ250×150mm |
Trace Gas for Leak Detection |
100% Helium |
Leak Detection Pressure |
0.1 ~ 0.6MPa |
Production Cycle Time |
10 min/piece |
Alarm Leak Rate |
≤1.0×10-9 Pa·m³/s |
ETIQUETAS CALIENTES :